Before physically installing your doorbell please make sure it is connected to your network. Please make sure to turn the power off at the breaker before handling any wiring.
Step 1: Apply the installation template to the surface and mark the drill holes. Drill two holes for the wall anchors plus a larger hole if you need to pass wiring through. Tap the anchors into the holes until they are flush with the wall. Place the mounting plate with the UP arrow facing up onto the surface and attach with the included thermal screws.
Step 2: For standard AC, connect the two tension wires to the rear screw terminals of the doorbell. Attach the extension wires to the existing wiring using the included wire nuts.
If using PoE, simply plug an Ethernet cable into the Ethernet port. An optional chime is included in the box that will sync with your doorbell. If using a mechanical chime you must install the included chime kit.
Step 3: Connect a wire to the transformer and the other to the chime’s “Front” terminal. Link the chime’s “Trans” terminal to the second power supply terminal to complete the loop.
Bridge the Chime Kit wires across both the “Front” and “Trans” terminals.
Step 4: Attached the doorbell. Align the back of the doorbell onto the mounting plate. Press to attach and secure it to the surface.
Note: If you need a better view you can install a 15° or 30° angled bracket between the wall and the mounting plate.